Feature1 - Cleaner / Generic / Feature Section / OFF )I didn't do it it was already set up. AUX3 - Spillway / Generic / Feature Section / OFF (I have an additional question below) AUX2 - Pool High / Generic / Feature Section / OFF ![]() AUX1 - Pool light / generic / Feature Section / OFF ![]() I used ScreenLogic Config to set up the circuits: (name / function / shown on on with freeze): I would like to have 2 hours at higher speed to clean the pool after we play with the dogs in the pool (to remove all dog hairs). pool high 6am - 7 am (I'm not sure if I set up this circuit properly, iChlor doesn't work with this)Īfter one day it looks like 8 hours at 1500 rpm (220 W) is enough to maintain ~ 3 ppm CL They start normally, however they don't stop when they should. Using screenLogic2 and ScreenLogic config on my phone I have set up several schedules. Everything looks good except I have problem to set up schedules. Yesterday new iChlor30, InteliFlo 3HP and ET4 with ScreenLogic2 were installed. ![]() Hello, I'm looking for some advice regarding the automation.
0 Comments
Leave a Reply. |